Line Item SupplyIndustrial Equipment
Request a Quote

Offices, people, and code · guide

Restroom fixture count: the guide

The plumbing code sets the toilets, sinks, and drinking fountains by occupancy and occupant load, and the occupant load it means is the code's, not the headcount.

Open the calculator

Why this number matters

The International Plumbing Code's Table 403.1 gives fixtures per occupant by use, with the occupants split evenly between men and women. Offices get a water closet for every 25 people up to 50 and every 50 after, a lavatory for every 40 to 80 and every 80 after; factories and warehouses get one of each per 100, because the occupant load factor already assumes a thin crowd. Urinals may replace up to two thirds of the men's water closets in offices and factories, a drinking fountain is required per 100 or 400, and every building gets a service sink.

The occupant load in the formula is the building code's, from the floor area and the use, which is usually higher than the real headcount; a 50,000 square foot warehouse is 100 occupants on paper with 20 people in it. Some officials accept the actual staffing for a warehouse, and the time to ask is before the restrooms are framed.

Small offices get relief: up to 15 occupants in a business occupancy may share one single-user restroom, and family or assisted-use restrooms count in both columns.

How it is figured

  • IPC Table 403.1, occupants split equally by sex (403.1.1): Business, water closets 1 per 25 for the first 50 and 1 per 50 after, lavatories 1 per 40 for the first 80 and 1 per 80 after, drinking fountain 1 per 100; Factory and Storage, 1 per 100 for water closets and lavatories, drinking fountain 1 per 400; one service sink in each.

A worked example

A 60-occupant office, 30 of each sex, needs two water closets and one lavatory for each sex, one drinking fountain, and a service sink; a 150-occupant warehouse needs one water closet and one lavatory each and a fountain.

The tool's starting values, and what it returns for them:

OccupancyBusiness (B): offices
Occupant load60 people
Water closets2 men + 2 women
Lavatories1 men + 1 women
Drinking fountains1
Service sink1
Occupants per sex30

Mistakes that catch people

  • Counting from the headcount and failing the plan review.
  • Forgetting the drinking fountain, or the second one at the low height.
  • Putting the plant's only restrooms where the second shift cannot reach them within the travel distance.

Rules of thumb

  • Business: WC 1:25 to 50, then 1:50; lavatory 1:40 to 80, then 1:80.
  • Factory and storage: 1:100 for both; fountain 1:400.
  • Up to 15 occupants: one single-user restroom may serve.

When to stop calculating and make a call

  • Every project: the official applies the local amendments and the occupant load.
  • Accessible fixtures: the ADA Standards govern the dimensions, not the count.

Questions people ask

Does the headcount or the occupant load govern?
The occupant load from the building code, which is usually higher than the real headcount. Some officials accept the actual number of employees for a warehouse; ask before designing.

Standards and sources

  • International Plumbing Code, Chapter 4, Table 403.1 and Section 403

This guide and the tool are planning aids. The equipment maker, the engineer of record, the accountant, or the code official confirms the final number for your building.