Line Item SupplyIndustrial Equipment
Request a Quote

Offices, people, and code · guide

Bollard count: the guide

Bollards go where something would otherwise be hit: a line along a wall or an edge at a set spacing, and a pair at every door, column, and piece of equipment.

Open the calculator

Why this number matters

A line of bollards protects a wall, a utility run, or an edge from vehicles that would clip it; the spacing sets what gets through. Four to five feet stops a forklift, six to eight marks an edge and lets a pallet jack pass. Doors and columns get a pair each, one at each jamb or corner. Surface-mount bollards on base plates with four anchors go in in an hour and come out when the layout changes; cast-in-place bollards, a 4-inch pipe 3 feet deep in a 12-inch concrete hole, are what stop a moving vehicle.

The count is simple arithmetic, but the decision between surface and cast-in is not: a surface bollard on a 6-inch slab will deflect a slow forklift and shear its anchors under a truck; anything at a dock, a gate, a gas meter, or a utility is cast in or crash rated. The concrete volume for the holes is part of the order.

Bollard sleeves and covers are the maintenance item: a plastic cover over a steel bollard keeps the paint on and is replaced after the hit.

How it is figured

  • Along a line: length ÷ spacing + 1. Each door jamb, column, or piece of equipment gets a pair. Surface-mount bollards take four anchors each; cast-in bollards take a cored hole whose concrete volume is π × (diameter/2)² × depth.

A worked example

One hundred twenty feet of wall at 5-foot spacing is 25 bollards, six door and column pairs add 12, 37 bollards with 148 wedge anchors surface-mounted, or 37 cored holes and about 4 yards of concrete cast in.

The tool's starting values, and what it returns for them:

Length to protect120 ft
Spacing5 ft
Doors, columns, and equipment that get a pair6
MountingSurface mount on base plate, 4 anchors
Bollards37
Wedge anchors148
Along the line25
Holes to core or dig0
  • Surface-mount bollards on a slab stop a slow forklift; a loaded truck at speed needs cast-in-place bollards or a crash-rated barrier.

Mistakes that catch people

  • Surface-mount bollards at a truck dock.
  • Spacing wide enough for the forklift to go between.
  • Forgetting the covers; bare bollards are repainted every year.

Rules of thumb

  • 4 to 5 feet apart to stop a forklift; 6 to 8 to mark an edge.
  • Surface mount for forklifts at walking speed; cast in for anything faster.
  • A pair at every door jamb, column, and piece of equipment.

When to stop calculating and make a call

  • Vehicle barriers at the building perimeter, gates, or pedestrian areas: ASTM F3016 or F2656 rated barriers, engineered.
  • Slabs of unknown thickness: core a hole and look before ordering anchors.

Questions people ask

Surface mount or cast in?
Surface-mount bollards on a 6 in. slab handle a forklift bump at walking speed and come out when the layout changes. Anything that must stop a vehicle, at a dock, a gate, or a utility, is set in concrete 3 ft deep or deeper.

Standards and sources

  • Bollard manufacturer installation guides (Omega, Ideal Shield)
  • ASTM F3016 (low-speed vehicle impact ratings), where rated protection is needed

This guide and the tool are planning aids. The equipment maker, the engineer of record, the accountant, or the code official confirms the final number for your building.