Line Item SupplyIndustrial Equipment
Request a Quote

Offices, people, and code · guide

Guardrail take-off: the guide

Guardrail is ordered as posts, rails, and anchors from a run length and a post spacing, and the openings and corners are what change the count.

Open the calculator

Why this number matters

A run of lift-truck guardrail is rails bolted between posts on 4 to 10 foot centers, each post on a base plate with four anchors into the slab. Divide the run by the spacing for the spans, add a post at the end of every run, and every opening for a door or an aisle ends two runs, so it adds a post. Double rail at 42 to 44 inches is the standard; a single low rail guards a wall from pallet jacks, triple rail guards a mezzanine edge, and the rails per span multiply accordingly.

Corners are counted inside the spans but want corner-drilled posts or brackets; the maker's order form has a line for them. Lift-off rails where forklifts occasionally need through are a separate item, and so are the drop-in posts for removable sections.

The impact-energy calculator sits beside this one for the question the rail is bought to answer: whether it stops the truck you have at the speed it goes.

How it is figured

  • Spans = run length ÷ post spacing, rounded up. Posts = spans + one end post per run (an opening makes two runs). Rail sections = spans × rails high; anchors = posts × anchors per post.
  • Corner posts are counted within the spans; order corner-drilled posts or a corner bracket for each.

A worked example

Two hundred feet of double rail on 8-foot centers with four corners and two openings is 25 spans, 28 posts, 50 rail sections, and 112 anchors.

The tool's starting values, and what it returns for them:

Total run length200 ft
Post spacing8 ft (standard)
Corners4
Openings (doors, aisles)2
Rails highDouble rail, 42 to 44 in. (standard)
Anchors per post4 (standard)
Posts with base plates28
Rail sections50
Wedge anchors112
Corner posts (included)4
Lineal feet of rail400 ft

Mistakes that catch people

  • Forgetting the end post at each opening.
  • Four-foot spacing where eight would do, or eight where the rail is rated for six.
  • Anchoring into a slab with no idea of its thickness; most makers want 5 inches of concrete under a 4-inch anchor.

Rules of thumb

  • Posts = spans + one per run; rails = spans × rails high.
  • Four 1/2 or 5/8 inch wedge anchors per post, 4 inches embedded.
  • Double rail 42 to 44 inches is the standard lift-truck height.

When to stop calculating and make a call

  • Fall protection on a mezzanine edge: OSHA 1910.29 rail, a different product with a mid-rail and toe board.
  • Crash-rated protection at a gate or a dock: engineered barriers, not guardrail.

Questions people ask

Is lift-truck guardrail the same as fall protection guardrail?
No. Lift-truck guardrail is heavy formed steel on 4 by 4 posts, built to take an impact; fall-protection rail on a mezzanine edge is sized by OSHA 1910.29 for a 200 lb load at 42 in. with a mid-rail and toe board. Ask for the right one.

Standards and sources

  • Guardrail manufacturer ordering guides (Omega, Wildeck, Cogan)
  • OSHA 1910.29 (guardrail systems for fall protection, where it applies)

This guide and the tool are planning aids. The equipment maker, the engineer of record, the accountant, or the code official confirms the final number for your building.