Offices, people, and code
Guardrail posts, rails, and anchors for a run
Run length, post spacing, corners, and gaps in; the posts, rail sections, base plates, and anchors to order.
Read the guide: what the number means and how to use it
- Spans = run length ÷ post spacing, rounded up. Posts = spans + one end post per run (an opening makes two runs). Rail sections = spans × rails high; anchors = posts × anchors per post.
- Corner posts are counted within the spans; order corner-drilled posts or a corner bracket for each.
Need it quoted?
In-plant offices sized to the headcount, pre-wired, with HVAC and restrooms, priced as line items.
Modular officesGuardrail take-off
Posts with base plates
28
25 spans plus an end post for each of 3 runs
Rail sections
50
25 spans × 2 rails, 8 ft each
Wedge anchors
112
4 per post, 1/2 or 5/8 x 4 in.
- Corner posts (included)
- 4
- Lineal feet of rail
- 400 ft
One line for the file or the vendor
200 ft of 2-rail guardrail at 8 ft centers, 4 corners, 2 openings: 28 posts, 50 rail sections, 112 anchors.
How it is figured
- Spans = run length ÷ post spacing, rounded up. Posts = spans + one end post per run (an opening makes two runs). Rail sections = spans × rails high; anchors = posts × anchors per post.
- Corner posts are counted within the spans; order corner-drilled posts or a corner bracket for each.
Sources: Guardrail manufacturer ordering guides (Omega, Wildeck, Cogan); OSHA 1910.29 (guardrail systems for fall protection, where it applies). A planning calculator; the maker, the engineer of record, or the code official confirms the final number.
Questions people ask
- Is lift-truck guardrail the same as fall protection guardrail?
- No. Lift-truck guardrail is heavy formed steel on 4 by 4 posts, built to take an impact; fall-protection rail on a mezzanine edge is sized by OSHA 1910.29 for a 200 lb load at 42 in. with a mid-rail and toe board. Ask for the right one.
Related calculators: Bollard count, Mezzanine floor and column loads, Forklift aisle width. All calculators.