Line Item SupplyIndustrial Equipment
Request a Quote

Metal building calculator

Roof and wall sheeting take-off for a metal building

Width, length, eave height, and pitch in; roof panel length and count, sidewall and endwall panels, square feet of sheeting, and the trim lineal feet out. Use it to budget a shell, sanity-check a quotation, or order sheeting for a re-skin.

  • Peak height and rafter slope length.
  • Panels round up to whole sheets, lengths to your cut increment.
  • Eave, rake, ridge, corner, and base trim.

Need the building priced?

Send the footprint, eave height, and openings and the quotation comes back with frames, sheeting, trim, insulation, and doors as line items.

Metal buildings

Gable building, symmetric, sheeting and trim take-off

Rise to the peak
1'-8"
Peak height
17'-8"
Rafter slope length, eave to peak
20'-0 3/4"
Roof panel length (slope + eave overhang, rounded up)
20'-4"
Roof panels
21 per side, 42 total, 2,562 sq ft
Sidewall panels
20 per side at 16'-0", 1,920 sq ft
Endwall panels, square cut (beam bottom + 5 1/2")
14 per endwall, 1,404 sq ft both ends, max step 0'-3"
Sheeting, all faces
5,886 sq ft

Trim

Eave trim or gutter, both sides120 lin ft
Rake trim, four rakes81 lin ft
Ridge cap60 lin ft
Corner trim, four corners64 lin ft
Base trim or angle200 lin ft

Gross take-off with no deduction for framed openings and no waste; add the openings' jamb and header trim and the maker's waste factor. Panel counts round up to whole sheets. The endwall lengths come from the endwall panel calculator.

Read the guide: what the number means and how to use it

Get the line card, or have it priced

One email with what you asked for. No list, no newsletter.

Questions erectors ask

How is the roof panel length figured?
The rafter slope length from the eave to the peak, plus the eave overhang measured along the slope, rounded up to the cut increment. A 40-foot-wide building on a 1:12 pitch has a 20-foot run, a 20-inch rise, and a slope just over 20 feet 1 inch, so a 3-inch overhang gives a 20-foot 4-inch roof sheet.
Why are endwall panels different lengths?
They run vertical and stop at the rake, so every panel is longer than the one nearer the corner. The square-cut method cuts them to the rake height at the low edge and lets the rake trim close the step; the endwall calculator shows every length and the cut list.
Does the take-off deduct for doors and windows?
No. It is a gross sheeting and trim count for budgeting and for checking a quotation. Framed openings add jamb and header trim and remove some panel area, and the building maker's bill of material governs the order.
What panel width should I use?
36-inch coverage for PBR and R panel, the usual exposed-fastener panels on industrial buildings. Concealed-fastener standing seam panels run 24, 18, or 16 inches, and the roof count changes with them.

Also: gable endwall panel lengths, metal building builder.