Line Item SupplyIndustrial Equipment
Request a Quote

By use: additions

Adding on: three ways to grow a metal building.

Metal buildings are easy to extend when the first building was planned for it and still workable when it was not. The right approach depends on which direction you are growing and what the existing building was designed to carry.

Isometric drawing of steel frames, purlins, girts, and cross bracing in a new building

Representative drawing of the equipment type, not the exact configuration quoted.

Lengthen it

Adding bays to the end is the simplest expansion. If the endwall was ordered as an expandable frame, the end panels come off and new frames continue the building. If the endwall is a light post-and-beam frame, it is replaced or a new frame is set beside it. The new bays are engineered to the current code and loads.

Isometric drawing of ribbed metal wall panels fastened to girts on steel columns

Representative drawing of the equipment type, not the exact configuration quoted.

Add a lean-to

A lean-to along a sidewall adds width with a single-slope frame that either bears on the existing columns or stands on its own columns beside them. Bearing on the existing building adds load to it and can create snow drift where the roofs meet, so the existing frames have to be checked. A self-supporting lean-to avoids both questions.

Set a new building beside it

When the existing building cannot take more load, or its drawings are not available, a separate building alongside with a connecting opening is often the cleanest answer. The two structures stay independent and the joint between them is flashed.

  • Send the original building drawings if you have them
  • Photographs of the frames, the endwall, and the building's data plate help
  • Tell us what happens in the new space and what it carries

Questions

Does the addition have to match the old building's code?
No. The addition is designed to the code and loads in force now. Depending on the size of the addition, the permit office may also ask for a check of the existing building where the addition affects it.
Can you match the existing panels and color?
A similar profile and color can usually be supplied, but weathered panels rarely match new ones exactly. A common approach is to break the wall at a trim line or a corner so the difference is not side by side.